Loading…

Protocol - Peak Expiratory Flow Rate (PEFR)

Add to Toolkit

Protocol Name from Source:

Not Applicable; see source

Availability:

Publicly available

Description:

A patient is instructed to inhale deeply and blow into a peak expiratory flow monitor three times. Peak expiratory flow rate (PEFR) can be measured as part of spirometry testing (see Spirometry measure) or as a separate measurement. The highest PEFR value is typically used for analysis.

Protocol:

Test Procedure

Peak Expiratory Flow Rate (PEFR) is dependent on effort and lung volume, with subject cooperation being essential. PEFR must be achieved as rapidly as possible and at as high a lung volume as possible, in order to obtain the maximum value. The subject must be encouraged to blow as vigorously as possible. The neck should be in a neutral position, not flexed or extended, and the subject must not cough. A nose clip is not necessary.

After the point of full lung inflation, the subject must deliver the blow without any delay. Hesitating for as little as 2s [seconds] or flexing the neck allows the tracheal visco-elastic properties to relax and PEFR to drop by as much as 10%. Tonguing, spitting or coughing at the start of the blow may falsely raise the recorded PEFR in some devices.

The subject must perform a minimum of three PEFR maneuvers. When PEFR is a self-administered recording used to monitor disease status, it is important that the subject has been adequately taught how to perform the test, when to perform it, and what action to take depending on the resulting value obtained.

Within-maneuver evaluation

The subject must be observed to ensure a good seal at the mouth, no hesitation occurred, and there was no abnormal start to the maneuver.

Between-maneuver evaluation

The PEFR values and their order must be recorded so that maneuver-induced bronchospasm can be detected. If the largest two out of three acceptable blows are not reproducible within 0.67 L s-1 (40 L min-1), up to two additional blows can be performed. Ninety-five percent of untrained healthy subjects and patients can reproduce PEFR to within 0.67 L s-1 (40 L min-1), and ninety percent to within 0.5 L s-1 (30 L min-1). If satisfactory repeatability has not been achieved in five attempts, more are not likely to be helpful.

Test result selection

The largest value from at least three acceptable blows is recorded.

Personnel and Training Required

A technician who is trained on how to use a peak flow meter or spirometer is required.

Equipment Needs

Peak expiratory flow rate (PEFR) requires an instrument that meets American Thoracic Society/European Respiratory Society (ATS/ERS) standards, which require a flat frequency response (+-5%) up to 15 Hz. PEFR can be measured using a spirometer; alternatively, simpler peak flow meters, which only measure PEFR, can be used.

Requirements

Requirement CategoryRequired
Average time of greater than 15 minutes in an unaffected individualNo
Major equipmentNo
Specialized requirements for biospecimen collectionNo
Specialized trainingYes

Mode of Administration

Self-administered

Life Stage:

Child, Adolescent, Adult, Senior

Specific Instructions:

A minimum of three acceptable blows is necessary. The maneuver can be performed in either the sitting or standing position, but one of these options should be used in a standardized manner within a particular study.

Research Domain Information

Release Date:

January 29, 2010

Definition

The peak expiratory flow rate measures airflow (maximum speed of expiration) and the presence and degree of obstruction in the airways.

Purpose

This test is commonly used to diagnose and monitor lung diseases such as asthma; less commonly, it is used in chronic obstructive pulmonary disease (COPD).

Selection Rationale

This is a simple method of measuring airway obstruction, and it will detect moderate or severe disease. The simplicity of the method is its main advantage.

Language

English

Standards

StandardNameIDSource
Common Data Elements (CDE)Person Peak Expiration Flow Rate Text2970241CDE Browser
Logical Observation Identifiers Names and Codes (LOINC)Resp peak expiratory flow rate proto62623-4LOINC

Process and Review

[link[phenx.org/node/118|Expert Review Panel #6]] (ERP 6) reviewed the measures in the Respiratory domain.

Guidance from ERP 6 includes:

• No significant changes to measure

Back-compatible: no changes to Data Dictionary

Source

Miller, M. R., Hankinson, J., Brusasco, V., Burgos, F., Casaburi, R., Coates, A., ... Wanger, J. (2005). Standardisation of spirometry. Series “ATS/ERS task force: Standardisation of lung function testing.” European Respiratory Journal, 26(2), 330-331.

General References

Shirley, D. K., Kaner, R. J., & Glesby, M. J. (2015). Screening for chronic obstructive pulmonary disease (COPD) in an urban HIV clinic: A pilot study. AIDS Patient Care STDS, 29(5), 232-239.

Protocol ID:

90801

Variables:

Export Variables
Variable NameVariable IDVariable DescriptionVersiondbGaP Mapping
PX090801_Peak_Expiratory_Flow_Rate1PX090801010000Peak Expiratory Flow Rate 14Variable Mapping
PX090801_Peak_Expiratory_Flow_Rate1_UnitsPX090801010100Peak Expiratory Flow Rate 1 units4N/A
PX090801_Peak_Expiratory_Flow_Rate2PX090801020000Peak Expiratory Flow Rate 24Variable Mapping
PX090801_Peak_Expiratory_Flow_Rate2_UnitsPX090801020100Peak Expiratory Flow Rate 2 units4N/A
PX090801_Peak_Expiratory_Flow_Rate3PX090801030000Peak Expiratory Flow Rate 34Variable Mapping
PX090801_Peak_Expiratory_Flow_Rate3_UnitsPX090801030100Peak Expiratory Flow Rate 3 units4N/A
PX090801_Max_Expiratory_Flow_RatePX090801040000Maximum Peak Expiratory Flow Rate 4N/A
PX090801_Max_Expiratory_Flow_Rate_UnitsPX090801040100Maximum Peak Expiratory Flow Rate units4N/A